Fibaro Z-Wave Dimmer Bypass 2

$25.00

This Fibaro Bypass 2 enables the Fibaro Dimmer 2 module to control loads that are below the 50W minimum requirement. The bypass stablises the lighting circuit and eliminate the flickering and light constantly on associated with insufficient load on the circuit.

SKU: FIB-FGB-002 Category:

Description

All z-wave dimmers require a minimun load on the light circuit otherwise it may not work. The Fibaro dimmer 2 is the newest and best module for low load light circuits and requires a minimum load of 50W however if you use it on a circuit with a load less than this you may encounter flickering and lights refusing to switch on or off.
This Fibaro Bypass 2 acts as a dummy load and increases the load above the 50W minimum to eliminate these issues.

This bypass only works for Fibaro Dimmer 2 so please do not use for Dimmer version 1 as it will burn out either device.

♦ Only use with the Fibaro Dimmer 2 module (not compatible with the older Fibaro Dimmer).

♦ Supports low-power lamps such as LEDs

♦ Fits into wall socket alongside the Dimmer module or inside the light fitting

♦ Easy installation by electrician